STEP 3 / 7

Middle-layer edges

Insert the four edges that have no yellow into the middle layer.

  1. You start with (input)First layer all correct
  2. Result you will get after finishing this stepFirst two layers all correct
Top
Bottom
Layers

Hold the cube like this

Before you start and all through this step: yellow centre on top, the finished white layer underneath.

The pieces to find: tap one to colour the cube for it

Which case do you have?

URU′R′U′F′UF

Keep the front

Before you compare and all through the formula: keep the front (the face marked FACING YOU in the pictures) turned towards you. A picture marked BACK, AWAY FROM YOU looks from behind: do not turn the cube, just tilt it to see the back.

Follow 3 steps

  1. 1. Hold the cube like this

    Yellow centre on top, the finished layer 1 (white) underneath. Keep it that way for this whole step.

    Top
    Bottom
  2. 2. Find these pieces

    Find the 4 edges with no yellow and bring them to their right place in this step.

    orange – green
    red – green
    orange – blue
    red – blue
  3. 3. For each piece

    • Turn until the edge’s side colour matches the front centre.
    • Find the case you have below, tap the picture and turn along.
    See the cases

More detail

  1. Yellow centre on top, the finished first layer (white) underneath.
  2. Find an edge in layer 3 with no yellow (neither colour is yellow).
  3. Turn until its side colour matches the front centre: edge and centre make an upside-down T.
  4. Look at the edge’s top colour: if it matches the right centre, insert it right; the left centre, insert it left.
  5. No such edge left on top but layer 2 is not done? One is stuck wrong in layer 2: use the last picture to push it out, then insert it.
  • Repeat for all four edges.

Check your result

Before the next step, compare your cube with these two pictures. They turn so you can see every side.

WrongThe edge is in the middle, but its colours are swapped.
RightBottom two layers: each side is one colour.
Mine looks right, go on
Was this step easy to understand?