STEP 1 / 7

The white cross

Place four white edges around the white centre, each side colour matching its centre.

  1. You start with (input)A scrambled cube
  2. Result you will get after finishing this stepWhite cross done
Top
Bottom
Layers

Hold the cube like this

Before you start and all through this step: white centre on top, yellow underneath.

The pieces to find: tap one to colour the cube for it

Which case do you have?

1. The edge is in layer 3 (at the bottom)

2. The edge is in layer 2

3. The edge is in layer 1 but wrong

F2

Keep the front

Before you compare and all through the formula: keep the front (the face marked FACING YOU in the pictures) turned towards you. A picture marked BACK, AWAY FROM YOU looks from behind: do not turn the cube, just tilt it to see the back.

Before you start: what is a Rubik’s cube made of?

A 3x3 cube has 26 small pieces of three kinds. You do not solve it "colour by colour": you put each piece in its place, one layer at a time from the bottom up.

6 centresOne colour, in the middle of each face. Centres never move relative to each other, so a centre’s colour is the colour of its whole face.
12 edgesTwo colours, between two corners. The white cross in step 1 is the 4 edges with a white sticker.
8 cornersThree colours, at the 8 tips. A corner’s three colours always move together.
Layer 1The layer with the white centre. Steps 1 and 2 finish it. Layers are named by colour, not position: on top in step 1, at the bottom from step 2.
Layer 2The middle layer: only 4 edges to place. Step 3.
Layer 3The layer with the yellow face, solved last in steps 4 to 7.

Follow 3 steps

  1. 1. Hold the cube like this

    White centre on top, yellow centre underneath. Keep it that way for this whole step.

    Top
    Bottom
  2. 2. Find these pieces

    Find the 4 edges with a white sticker and bring them to their right place in this step.

    white – green
    white – red
    white – blue
    white – orange
  3. 3. For each piece

    • Turn the whole cube so the matching centre is at the front.
    • Find the case you have below, tap the picture and turn along.
    See the cases

More detail

  1. Hold the cube white centre on top. The white cross is the 4 edges with a white sticker of layer 1 (the layer with the white centre, on top for now). Place them one at a time: 1/4, 2/4, 3/4, then 4/4.
  2. Find an edge with a white sticker and look at its other colour (say green). Turn the whole cube so the green centre is at the front.
  3. See which layer the edge is in: layer 3 (at the bottom for now), layer 2 (the middle) or layer 1 (on top). The pictures below are grouped the same way.
  4. Layer 3: turn the bottom () until the edge sits right below the front centre, then see if its white sticker is on the bottom or the front.
  5. Layer 2: the edge sits in one of the 4 upright spots of layer 2: front or back, right or left. See which face its white sticker is on.
  6. Layer 1 but wrong: in its own spot with white on the front, use the picture. Anywhere else in layer 1: turn the side face holding it twice (say ) to bring it down to layer 3, then follow group 1 (the last picture is an example).
  7. One edge done, find the next. With all 4, go to the next step: the page shows pictures to check your result first.

One piece at a time, until all 4 are in

  1. 1/4
  2. 2/4
  3. 3/4
  4. 4/4
  • Repeat for all four white edges.
  • No match yet? Turn the bottom layer () to bring the edge to the front, then compare again.

Check your result

Before the next step, compare your cube with these two pictures. They turn so you can see every side.

WrongA white cross, but the side colours do not match the centres.
RightEach edge’s side colour matches the centre below it.
Mine looks right, go on
Was this step easy to understand?