STEP 2 / 7

First-layer corners

Place the four white corners to finish the whole first layer.

  1. You start with (input)White cross done
  2. Result you will get after finishing this stepFirst layer all correct
Top
Bottom
Layers

Hold the cube like this

Before you start and all through this step: yellow centre on top, white underneath.

The pieces to find: tap one to colour the cube for it

Which case do you have?

1. The corner is in layer 3, right above its spot

2. The corner is in layer 1 but wrong

RUR′

Keep the front

Before you compare and all through the formula: keep the front (the face marked FACING YOU in the pictures) turned towards you. A picture marked BACK, AWAY FROM YOU looks from behind: do not turn the cube, just tilt it to see the back.

Follow 3 steps

  1. 1. Hold the cube like this

    Turn it over: yellow centre on top, white centre (the white cross) underneath. Keep it that way for this whole step.

    Top
    Bottom
  2. 2. Find these pieces

    Find the 4 corners with a white sticker and bring them to their right place in this step. They can be in layer 3 (on top), or already in layer 1 but in the wrong spot or twisted. A corner that is already right (all 3 colours match the 3 centres) stays as it is: these moves do not undo it.

    white – orange – green
    white – red – green
    white – orange – blue
    white – red – blue
  3. 3. For each piece

    • Find a corner with a white sticker in layer 3 (on top). Turn the whole cube so its 2 matching centres are at the front and right.
    • Turn until the corner sits right above its spot: the bottom front-right corner (marked with an X in the pictures).
    • See which face the corner’s white sticker is on: right, front or top.
    • Find the case you have below (the picture with white on the same face), tap it and turn along.
    See the cases

More detail

  1. Turn it over: yellow centre on top, the white cross (layer 1) underneath. Keep yellow on top until the last step.
  2. Find a corner with a white sticker in layer 3 (on top). A corner has 3 colours: white and two others (say red and green).
  3. Its spot is in layer 1, between the two matching centres (red and green). Turn the whole cube so those centres are at the front and right.
  4. Turn the top () until the corner is right above its spot: the bottom front-right corner. The pictures mark that spot with an X.
  5. See which face the white sticker is on: the right face (the right side of the cube), the front (the face towards you) or the top (the face with the yellow centre). Follow the matching picture. Repeat for all 4 corners; a corner that is already right stays.
  6. A white corner already in layer 1 but in the wrong spot or twisted? Turn the whole cube so it is at the bottom front right, do to pop it up to layer 3, then go on as above (the last picture).

One piece at a time, until all 4 are in

  1. 1/4
  2. 2/4
  3. 3/4
  4. 4/4
  • Repeat for all four corners.
  • Corner in layer 3 but not right above its spot? Turn first. The white sticker moves with it, so look again after the turn.
  • Forgot the pictures? With the corner right above its spot (front right), repeat until it drops in: at most 5 times (white on the right 1 time, on top 3, on the front 5). The white cross stays intact.

Check your result

Before the next step, compare your cube with these two pictures. They turn so you can see every side.

WrongThe corner is in place, but its white sticker shows on a side.
RightEach side’s bottom row matches its centre: an upside-down T.
Mine looks right, go on
Was this step easy to understand?