ROUX · STEP 5 / 7

Orient the edges

Flip the last six edges so their yellow or white sticker is on the top or bottom.

  1. You start with (input)Place the top corners
  2. Result you will get after finishing this stepOrient the edges

Follow 3 steps

  1. 1. Hold the cube like this

    Turn until the top centre is yellow or white. From here to the end, only and .

    Top
    Bottom
  2. 2. Find these pieces

    Look at the 6 edges left: 4 in the middle column and 2 at top left and top right. A wrong one has its yellow or white sticker on a side.

    yellow – green
    yellow – blue
    white – green
    white – blue
    yellow – orange
    yellow – red
  3. 3. Flip the wrong edges

    • Count the wrong edges (always an even number). All 6 wrong: do once first.
    • Find the matching picture below and turn to line it up.
    • Tap the picture and turn along. Then every yellow and white sticker is on the top or bottom.
    See the cases

More detail

  1. Both blocks and the 4 corners are done. Exactly 6 edges are left: 4 in the middle column (front top, back top, front bottom, back bottom) and 2 at top left and top right.
  2. From here to the end turn only and . is the middle layer between the left and right faces, turned like (see the notation page).
  3. Turn until the top centre is yellow or white.
  4. An edge is good when its yellow or white sticker is on the top or bottom; bad when it is on a side.
  5. Reading the pictures (steps 5 to 7): the 3D cube as in earlier steps; the pieces to watch have a yellow ring and arrows show where they go. When a piece sits at the back bottom, the picture looks from below or from behind (marked BACK). Grey stickers do not matter.
  6. Count the bad edges (always an even number), turn to match a picture and follow it. All 6 bad: do once, which leaves 2 bad, then compare.

Which case do you have?

Before you compare and all through the formula: keep the front (the face marked FACING YOU in the pictures) turned towards you. A picture marked BACK, AWAY FROM YOU looks from behind: do not turn the cube, just tilt it to see the back.

M′UM
  • The back bottom edge is hidden: tilt the cube to look.
  • Top corners off the blocks is fine. A later step lines them up.
Was this step easy to understand?